The Official Sequential/Oberheim Forum

SEQUENTIAL/DSI => Pro 3 => Topic started by: Kusho on April 12, 2024, 01:23:42 PM

Title: Sequencer: Pressing key restarts sequence from step 1?
Post by: Kusho on April 12, 2024, 01:23:42 PM

The manual says:

To transpose a sequence up or down during playback:
1. Press the play button to hear the sequence.
2. Press a note on the keyboard above or below middle C. The sequence is
transposed to that key. (Middle C plays the sequence as recorded.) For
greater range, use the Transpose Up or Transpose Down buttons.
3. During playback, if you want to restart a sequence from step 1, press
the reset button.

However, the sequence restarts from step one when pressing a key. I would think there should be a setting to turn this on or off but I can't find such a setting?

Title: Re: Sequencer: Pressing key restarts sequence from step 1?
Post by: Jonah66 on April 12, 2024, 02:36:51 PM

Press Arp button-top right > Seq Params(2nd button below oled display) >3rd encoder = seq restart 0n, off.

Title: Re: Sequencer: Pressing key restarts sequence from step 1?
Post by: Kusho on April 12, 2024, 02:39:36 PM

Quote from: Jonah66 on April 12, 2024, 02:36:51 PM

Press Arp button-top right > Seq Params(2nd button below oled display) >3rd encoder = seq restart 0n, off.

Hey thanks so much, didn't seem to be in the manual.
Good to remember to check the display screen for each function for extra settings!

Title: Re: Sequencer: Pressing key restarts sequence from step 1?
Post by: Jonah66 on April 14, 2024, 01:34:19 PM

Yeah there’s quite a few anomalies with the pro3 interface, I love the Pro3 sound though 😀