Prophet Rev2-Send midi notes ARP+SEQ since firmware 1.1.5.9

[vebeix]

Hi,
Isn't the firmware 1.1.5.9 on the Prophet Rev 2 supposed to allow the transfer of midi data from sequencer and arpeggiator?

Since the update I have 2 new sections concerning the arpeggiator in the global menu. Ok, but no notes from the sequencer are sent, and only those that I play for the arpeggiator.

Otherwise the hour after the update was very strange: all programs have been replaced by one (on all progs and all banks). Restarts did nothing. And all the programs have reappeared !! I do not know why. Creepy for gig (the REV-2 will often be driven by ableton Live).

Anyone? Any idea where can it come from? Is it possible to send midi notes from arp & seq to daw?
Thanks a lot !

[RobustAmerican]

Works here. With local control turned off I just get the notes that are played to trigger the arp/seq. With local control turned on I get the actual notes output by the arp/seq. So try it with local control turned on.

Almost forgot...Make sure Global page 13 is turned on. "MIDI Arp+Seq"

[shiihs]

Hi,
Isn't the firmware 1.1.5.9 on the Prophet Rev 2 supposed to allow the transfer of midi data from sequencer and arpeggiator?

Since the update I have 2 new sections concerning the arpeggiator in the global menu. Ok, but no notes from the sequencer are sent, and only those that I play for the arpeggiator.

Otherwise the hour after the update was very strange: all programs have been replaced by one (on all progs and all banks). Restarts did nothing. And all the programs have reappeared !! I do not know why. Creepy for gig (the REV-2 will often be driven by ableton Live).

Anyone? Any idea where can it come from? Is it possible to send midi notes from arp & seq to daw?
Thanks a lot !

Just a side note: after upgrading firmware it's a good idea to "reset globals".
Not doing this can result in weird behavior.
1. Press the global button.
2. Use the parameter knob to select reset globals, then press write.