Hi everyone,
This is my first post/comment on the forum ever so I apologise if this question has been asked already. I've had my Rev2 since the end of November and I've not had time to do much exploring as yet. I noticed today that the sustain for the envelopes is not assignable as a destination to modulate. If DSI updated the firmware or something would this be made possible or is this something that cannot be changed?
Cheers
Elliott
The sustain stage has never been available as a modulation destination on any synth, or at least none I can currently think of. It's a level parameter, not a temporal parameter like Delay, Attack, Decay, and Release. You can implicitly modulate it by modulating the filter cutoff or the VCA level directly, depending on what level you'd like to modulate.
My apologies for the extreme late reply on this one haha! This is something I have done on my MatrixBrute which was the first big boy synth I purchased!
I have a few synths where the sustain stage can be a modulation destination like in the MatrixBrute.
Alesis Andromeda, Fusion, and Micron
Moog Slim Phatty and Minitaur have it as a destination CC
My Moog One has in its Mod matrix EG1,2,3 sustain as a destination
Would be nice to see sustain as a destination in the Rev2, esp for the filter envelope.
Although, I'd prefer to have
polyphonic unison first, as that is much more useful for fattening up voices while retaining polyphony, especially in split mode.